|
Title: what to do.... Post by: GSXRBOBBY on July 31, 2004, 03:58:30 pm I bought a motor to do a swap about 9 months ago and I am now getting close to do the swap. Its been setting on the engine stand since just as it was pulled out of the Cadillac STS.
I am already planning on changing the oil, oil filter, plugs and wires. I am going to have the fuel injectors cleaned out of the engine, "somewhere that has a bench mechine". Is there anything else that can be or should be done that I can't think about right now? Title: Re: what to do.... Post by: GoFast85 on August 03, 2004, 09:42:31 am A simple thing, but valve cover gaskets. They are only about $30 but are easy to install when the engine is out but a @!#$% to change when it is tight in the engine bay.
Title: Re: what to do.... Post by: GSXRBOBBY on August 04, 2004, 01:19:51 am The what was front was removed and replaced but I wouldn't say easy, that cam pully was a bit** to remove!
|