|
Title: 84-86 Fiero/Ferrari Kit Post by: runitca on November 28, 2004, 10:21:24 pm After visiting jdinner’s shop and looking at his progress on the chassis and how it looked in person I have decided to abandon this project before I get to involved with it. I have replaced all the body mounts and trial fitted the body. Everything that comes with the price is listed bellow I would be willing to separate if I can recoup most of my investment. The car is located in Canada about 2 hrs from Buffalo and 3 hrs from Detroit.
The Donor car (84' frame with 86' v6 electronics and engine. A/C, 4spd manual transmission Power Everything, front nose support welded in, hood hinged, frame already re-enforcements. Aftermarket power locks hooked into alarm. Calipers, all 4 corners Rotors, All 4 Corners Pads, all 4 Corners Clutch Water pump Bearings, Front Drive Axle, CV Joint and Tranny Seal EGR Tube Distributor (Cap, Rotor, Pickup coil) Shift cable TPS Sensor MAP Sensor Ignition Lock Cylinder Ball Joint, Rear left Door Lock Actuators Prestige (Audiovox) Alarm System w/ starter disable 1.5" Suspension Techniques Lowering Springs Battery Aftermarket Rearview mirror with Map Lights four tail lights two turn signals two "H4" headlight housing w/ bulbs Ferrari "style" wheel centers/ registration stickers 4 Wheel Spacers $5,200.00 U.S. or $6,250.00 Canadian You can email me at robw@supersan.on.ca or call 519-465-7999 Title: Re: 84-86 Fiero/Ferrari Kit Post by: runitca on December 06, 2004, 10:34:37 pm Here are a few pics
Title: Re: 84-86 Fiero/Ferrari Kit Post by: fiero308 on December 07, 2004, 10:58:36 am geez it looks like a nice project and that would HAVE to be an appealing price?!?!?!?
The body kit alone must be more than that I have no doubt. Any particular reason you are not going to continue? Are there major pieces missing or something? I suppose those are questions anyone will ask at some point, so maybe post them too. But that is a really nice body style!! Good luck and keep everyone posted! |