After visiting jdinner’s shop and looking at his progress on the chassis and how it looked in person I have decided to abandon this project before I get to involved with it. I have replaced all the body mounts and trial fitted the body. Everything that comes with the price is listed bellow I would be willing to separate if I can recoup most of my investment. The car is located in Canada about 2 hrs from Buffalo and 3 hrs from Detroit.
The Donor car (84' frame with 86' v6 electronics and engine. A/C, 4spd manual transmission Power Everything, front nose support welded in, hood hinged, frame already re-enforcements. Aftermarket power locks hooked into alarm.
Calipers, all 4 corners
Rotors, All 4 Corners
Pads, all 4 Corners
Clutch
Water pump
Bearings, Front
Drive Axle, CV Joint and Tranny Seal
EGR Tube
Distributor (Cap, Rotor, Pickup coil)
Shift cable
TPS Sensor
MAP Sensor
Ignition Lock Cylinder
Ball Joint, Rear left
Door Lock Actuators
Prestige (Audiovox) Alarm System w/ starter disable
1.5" Suspension Techniques Lowering Springs
Battery
Aftermarket Rearview mirror with Map Lights
four tail lights
two turn signals
two "H4" headlight housing w/ bulbs
Ferrari "style" wheel centers/ registration stickers
4 Wheel Spacers
$5,200.00 U.S. or $6,250.00 Canadian
You can email me at
robw@supersan.on.ca or call 519-465-7999
Author