Welcome, Guest. Please login or register.
Did you miss your activation email?
November 01, 2024, 07:32:57 am
Home Help Search Login Register

Ottawa Fiero Club Forum  |  General  |  General Chat  |  Topic: Duke ECM CTS « previous next »
Pages: [1] Go Down Print
Author Topic: Duke ECM CTS  (Read 1121 times)
dguy
Global Moderator
OFC Post-a-holic
*****
Offline Offline

Posts: 2598


Got vacuum. Want boost.
« on: November 29, 2004, 08:31:56 am »
Could anyone who has a 85-86 2.5 please check the sensor at the base of the thermostat housing and tell me whether theirs has a plastic shroud surrounding it or not?

I know the 84's have them, but I can't remember if on the later model engines the shroud is missing by intent, or in our case by accident.  Huh
« Last Edit: November 29, 2004, 08:33:45 am by Don Guy » Logged
1984: Track car project.
1985 SE: Dead 2.8, stalled L67 swap.
Kevin
Ottawa Fiero Member
MASTER FIERO
*****
Offline Offline

Posts: 637
« Reply #1 on: November 29, 2004, 08:53:23 am »
  Is it sensor that goes into the round bottom part of the housing? If this is what you are looking at mine does not have a shroud. Kevin
Logged
dguy
Global Moderator
OFC Post-a-holic
*****
Offline Offline

Posts: 2598


Got vacuum. Want boost.
« Reply #2 on: November 29, 2004, 09:19:07 am »
That's the one...  thanks!
Logged
1984: Track car project.
1985 SE: Dead 2.8, stalled L67 swap.
2ML67
Guest
« Reply #3 on: November 29, 2004, 11:07:30 am »
The shroud was to help keep it from falling off on the 84's and 85's. 86 up used a different clipping type two pin connector. by changing the plug you can use either but if you want to buy a new sensor most places only carry the 86 up one. Dan
Logged
Pages: [1] Go Up Print 
Ottawa Fiero Club Forum  |  General  |  General Chat  |  Topic: Duke ECM CTS « previous next »
Jump to:  


Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!